• Webster's Revised Unabridged Dictionary
    • n Superheater (Steam Engine) An apparatus for superheating steam.
    • ***
Century Dictionary and Cyclopedia
    • n superheater In a steam-engine, a contrivance for increasing the temperature of the steam to the amount it would lose on its way from the boiler until exhausted from the cylinder. This end is frequently attained by making the steam travel through a number of small tubes several times across the uptake, or foot of the chimney, before it enters the steam-pipe.
    • ***


In literature:

The boilers are 125-h.p., Sterling, water-tube, with Foster superheaters, and 33-in.
"The Water Supply of the El Paso and Southwestern Railway from Carrizozo to Santa Rosa, N. Mex." by J. L. Campbell
It is proposed to employ superheaters to the entire boiler plant.
"The New York Subway" by Anonymous
What is the duty of the superheater damper, and how does it operate?
"The Traveling Engineers' Association" by Anonymous
An endless stream of garments advanced through electric superheaters in parallel columns.
"A Labrador Doctor" by Wilfred Thomason Grenfell
It is in this chamber that a superheater is installed where such an apparatus is desired.
"Steam, Its Generation and Use" by Babcock & Wilcox Co.
The higher superheats have been found to increase the economy to a considerable extent.
"Steam Turbines" by Hubert E. Collins
The brick arch in the fire-box: A sort of second cousin to the superheater.
"Our Railroads To-Morrow" by Edward Hungerford

In news:

The valve calculates and adapts refrigerant flow to each circuit by using only one superheat sensor mounted at the evaporator outlet.
Evaporator has more than nine degrees of superheat.
Compressor has more than 25 degrees of total superheat.
Superheat is probably the most talked about yet misunderstood technical term used by service technicians in the field.
Superheat is a measured value.
Subcooling and superheat can be used to effectively check the proper operation of any air conditioning system.
A complete understanding of superheat and subcooling are keys to performing an accurate troubleshooting session.
As energy costs increase and air conditioning system efficiency becomes more critical, the need for accurate superheat measurements becomes more important.
Unfortunately, many technicians take shortcuts when it comes to performing their superheat calculations.
Revision of A249 / A249M - 10a Standard Specification for Welded Austenitic Steel Boiler, Superheater , Heat-Exchanger, and Condenser Tubes.
Series HSV electric expansion valves offers precise superheat control.
Revision of A249 / A249M - 10a Standard Specification for Welded Austenitic Steel Boiler , Superheater, Heat-Exchanger, and Condenser Tubes.
Contractor Mike Elsner of G and W Service holds the remote panel display below the superheat controller.

In science:

E is given by the superheat factor SA(E) = 1-Ethr set as low as 6.5 keV before onset of the gel melting at 45oC; the stopping power is (cid:11) 100 keV/┬Ám for temperatures up to ~ 5oC above the gel melting point.
A CF3I-based SDD Prototype for Spin-independent Dark Matter Searches